ChemWorld Sprinkler Treatment

• So add only 0.5% BV is needed for wet storage and 1.0% BV is needed for dry storage.
• ChemWorld RP W-VCI is fully synthetic and oil-free.
• ChemWorld RP W-VCI contains VCI preventatives that prevent corrosion on ferrous and copper based metals even where areas of the pipeline have not touched the fluid itself.
• ChemWorld RP W-VCI contains bacteria-static additives that minimize/prevent the formation of bacteria and fungus.
• ChemWorld RP W-VCI does NOT contain wax or other film forming agents that can plug filters and post processes.
• ChemWorld RP W-VCI will rinse out completely if/when they decide to flush water or oil through the pipeline again.
• ChemWorld RP W-VCI easily mixes with the base water and is near-clear to completely clear at use concentrations.
• Note: Prior to adding RP W-VCI to the base water for mixing, verify that the pH of the water is between 6.0 and 9.5. Adjust if necessary. The attached photos are testing the treatment at an independent lab, at 0.5% BV, for 1-month, in the presence of steel, steel wool, copper and brass, in highly corrosive make-up water. If the product were not to work, the solution would turn orange or light brown within just 1-hour....this is after 30-days.

• If you charge the system with water, AND LEAVE THE PIPELINE WET AND FULLY CHARGED WITH THE WATER SOLUTION, add 0.5% by volume of ChemWorld RP W-VCI. To treat 1,000 gallons of fluid, you would charge the system with 5 gallons of product and mix. That is (12) 55-gallon drums.

• If you charge the system with water, AND FLUSH AND COMPLETELY DUMP AFTER CHARGING, they need to add 1% by volume ChemWorld RP W-VCI to leave the appropriate rust preventative film. To treat 500 gallons of fluid, they would charge the system with 5 gallon of product and mix.